My Hampton bay wireless doorbell just stopped working. Changed all batteries. That not the problem. Only about 6 Months old. Was working perfectly. What could be the problem

i have a problem with remote ceailing fan and light i tried push on light key - dim light low to high working but fan isnt working hi to low. i checked the supply wire red, white and black so i have a installing receiver and receiver have red receiver wire to black supply wire, white receiver wire to white supply wire , but what i do with red supply wire to QQQQ

The Remote (TRANSMITTER) control AND the RECEIVER must both be set to the same CODE in order for the REMOTE to operate the fan.

!!WARNING!! YOU ARE ABOUT TO ENTER HIGH VOLTAGE ELECTRICITY ZONE!!

The RECEIVER is located in the CANOPY, the part of the fan assembly next to the ceiling which is also called the Hanger Bracket.

At the bottom of the Canopy you will see what looks like a large flat washer. Rotate the washer counter-clock wise to release it.

Then rotate the Canopy counter-clock wise to release and lower it. You will see the RECEIVER, which will have a short antenna at one end, tucked in among the electrical wire and bracket. Simply pull the RECEIVER out and you will see the CODE switches. Remember to set both devices to the same CODE.

Good luck. :)

Check the contactor in the doorbell. It may have some "yuk" on it preventing it from making contact.

I checked the hampton bay site and unfortunately whatever dip switch setting on the fan is, the remote needs to be matched to it. better get out the ladder!

Try following the problem solving from the instructions: http://media.chbyron.eu/file/pdf/SX86_EU-IS_-30-01-09_instructions.pdf

Posted on

More: