Sharp carousel microwave

Stopped working without power. Unplugging and replugging as recommended to reset the microwave allowed to set the clock. When opening of the door or starting the microwave, the display disappears with no buttons responding. Is the problem with the fuse?

Normally the problem is not the spring, but a broken spring mounting tab on the door latch head (hook) assembly or the inner door panel.

If it's the door panel, it's usually easier and cheaper to use epoxy and some kind of hardware to fashion a new spring mount.

The door latch head (hook) is easy to replace or repair if that's the issue.

We have *critical* safety & disassembly info at our site, linked here: http://tinyurl.com/yzjozk

We also have this full service manual at our site: http://www.microwavedisplay.com/R1480_R1481_R1482_sm.pdf

Normally you have to separate the door panels (as shown in the attached photo) and then you'll see the screws you need to remove.

We're happy to help and we appreciate your thoughtful rating of our answer.

8b26738.jpg

Touch STOP/CLEAR pad.
Touch TIMER/CLOCK pad.
Enter the correct time of day by touching the numbers above in sequence.
(for example: for 12:30, touch 1 2 3 0)
Touch TIMER/CLOCK pad again.

Stay away from Microwavedisplay.com and William E Miller. He will take your money and will not return your display unit let alone repairing it. Do your research. There are a lot of us out there!!!

You may need your main control panel repaired

IT IS POSIBLE TO HAVE A BURNED FUSE ON THEI Main boARD OF THE OVEN

A microwave can be dead for many reasons.

The fuse is normally located on the floor of the chassis behind the control panel or between the door switches.

If the fuse is good, it may be an open thermostat or thermal cutout (TCO) / thermal fuse on or near the magnetron or on top of the cavity / body of the oven.

If it goes dead for a while during or after cooking then comes back on, the magnetron is probably overheating and causing the magnetron thermostat to open.

Then when it cools, it closes the circuit and allows power through again.

When checking thermostats, if it has a hood fan thermostat, that should read open, as opposed to the others, which should read closed.

If it went dead almost immediately after pressing the Start pad, that's usually a shorted high-voltage capacitor.

If it went dead a few seconds after pressing the Start pad, that's usually a failing high-voltage transformer.

If it goes dead or blows the breaker when you plug it in or open or close the door, then there's a problem with a door switch or door switch mount.

If it's intermittent or random, it may be a bad connection, usually on the control board or a loose fuse holder, or even an intermittent fuse.

You should do a continuity test on the fuse while it's in the holder (with the microwave unplugged, of course) then turn the fuse by hand or take it out and put it back in, then test it again.

If you remove the fuse, then press the meter leads against the ends, it can allow internal contact to be made and make a bad fuse appear to be good.

If you or someone you know decide to look into it, we have critical safety information and disassembly information at our site, and our link is at our listing here on FixYa: http://tinyurl.com/yzjozk

We're happy to help and we appreciate your thoughtful rating of our answer.

Posted on

More: