Outside temp sensor located at inner fairing, it is tied to left fairing frame just above cigarette lighter.
On OEM parts,
Air Temp Gauge pin#1 = Orange +12 Volt
Air Temp Gauge pin#2 = Black - ground
Air Temp Gauge pin#3 = Air Temp sensor pin#1
Not too hard - Undo the two bolts on the caliper and then seperate the caliper and pull the old ones out. Insert the new ones and put the bolts back in to hold the caliper back together and then install them back on the bike with the two retaining bolts. Use a bit of lock tight (Blue) on the threads. Warning do not let anyone apply pressure on the brakes while you have them off the bike or you will have a mess and/or a problem.
Turn the Bike on and the Radio off and then follow the buttons on the screen. Most people think you have to do it while it is running and this does not work
Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.
0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.
All in all a pretty easy (but possibloy messy) job.
The oil pan is on the bottom of the transmission. Look under the transmission and you'll see two drain plugs. The one closest to the front left corner is the engine oil drain. The one closest to the center is the transmission drain.